O Nitrobenzoic Acid Synthesis Essay

552-16-9(2-Nitrobenzoic acid)Related Search:

O-NITRO ANISOLE (2-NITRO ANISOLE)Folic acid2-Nitrotoluene3-METHYL-2-NITROBENZOIC ACID2-Chloro-5-nitrobenzoic acid2-Nitro-4-methylsulfonylbenzoic acid3-NITROBENZOIC ACIDASCORBICACID3,5-Dinitrobenzoic acid2-Nitrobenzaldehyde3-METHYL-4-NITROBENZOIC ACIDACETIC ACIDHyaluronic acid2-Ethylnitrobenzene2-Nitrophenol2-Nitro-4-methylsulfonyltoluene2-Nitrobenzoyl chloride3-METHYL-6-NITROBENZOIC ACID

  • Benzoicacid,2-nitro-
  • o-carboxynitrobenzene
  • o-Nitrobenaoicacid
  • o-nitro-benzoicaci
  • Reagents for Oligosaccharide Synthesis
  • 552-16-9
  • Building Blocks
  • Carbonyl Compounds
  • Carboxylic Acids
  • C7
  • LABOTEST-BB LT00853998
  • Organic Building Blocks
  • OTAVA-BB BB0125160260
  • 2-Nitrobenzoicacid,95%
  • 2-nitrobenzoic
  • 2-nitro-benzoicaci
  • Benzoic acid, o-nitro-
  • 2-Nitrobenzoic acid, 85-90%
  • Aromatic Carboxylic Acids, Amides, Anilides, Anhydrides & Salts
  • Biochemistry
  • Reagents for Oligosaccharide Synthesis
  • C7
  • Carbonyl Compounds
  • Carboxylic Acids
  • O2NC6H4CO2H
  • 2-Nitrobenzoic acid ,98%
  • 2-Nitrobenzoic acid, synthesis grade
  • Building Blocks
  • Carbonyl Compounds
  • Carboxylic Acids
  • Chemical Synthesis
  • Organic Building Blocks
  • Nitrobenzoic aci
  • carboxylic acid| nitro-compound
  • 2-Nitrobenzoic acid 95%, Contains 3- and 4-isoMers
  • Adjacent nitro benzoic acid
  • 2-Nitrobenzoic acid Vetec(TM) reagent grade, 94%
  • Pharmaceutical Intermediates
  • Pyridines

Add to MyChemicalsPrint Friendly Page

Chemical Datasheet

Chemical Identifiers | Hazards | Response Recommendations | Physical Properties | Regulatory Information | Alternate Chemical Names

Chemical Identifiers

CAS NumberUN/NA NumberDOT Hazard LabelUSCG CHRIS Code
nonedata unavailablenone

NFPA 704

data unavailable

NIOSH Pocket GuideInternational Chem Safety Card

General Description

PHYSICAL DESCRIPTION: Yellowish white crystals with an intensely sweet taste. (NTP, 1992)


Reactivity Alerts


Air & Water Reactions

Insoluble in water.

Fire Hazard

Flash point data concerning this compound are not available, however, it is probably combustible. (NTP, 1992)

Health Hazard

ACUTE/CHRONIC HAZARDS: When this compound is heated to decomposition it emits very toxic fumes. (NTP, 1992)

Reactivity Profile

O-NITROBENZOIC ACID is incompatible with strong oxidizing agents. Also incompatible with strong bases. May react with cyanides (NTP, 1992).

Belongs to the Following Reactive Group(s)

Potentially Incompatible Absorbents

Use caution: Liquids with this reactive group classification have been known to react with the absorbents listed below. More info about absorbents, including situations to watch out for...

  • Cellulose-Based Absorbents
  • Expanded Polymeric Absorbents

Response Recommendations

Isolation and Evacuation

No information available.


Fires involving this compound can be controlled using a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)

Non-Fire Response

SMALL SPILLS AND LEAKAGE: Should a spill occur while you are handling this chemical, FIRST REMOVE ALL SOURCES OF IGNITION, then you should dampen the solid spill material with ethanol and transfer the dampened material to a suitable container. Use absorbent paper dampened with ethanol to pick up any remaining material. Seal the absorbent paper, and any of your clothes, which may be contaminated, in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with ethanol followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.

STORAGE PRECAUTIONS: You should store this material in a refrigerator. (NTP, 1992)

Protective Clothing

RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)

DuPont Tychem® Suit Fabrics

No information available.

First Aid

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.

INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.

INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)

Physical Properties

Chemical Formula:

Flash Point: data unavailable

Lower Explosive Limit (LEL): data unavailable

Upper Explosive Limit (UEL): data unavailable

Autoignition Temperature: data unavailable

Melting Point: 297 to 298 ° F (NTP, 1992)

Vapor Pressure: data unavailable

Vapor Density (Relative to Air): data unavailable

Specific Gravity: 1.575 at 68 ° F (NTP, 1992)

Boiling Point: data unavailable

Molecular Weight: 167.12 (NTP, 1992)

Water Solubility: less than 1 mg/mL at 73° F (NTP, 1992)

Ionization Potential: data unavailable

IDLH: data unavailable

AEGLs (Acute Exposure Guideline Levels)

No AEGL information available.

ERPGs (Emergency Response Planning Guidelines)

No ERPG information available.

PACs (Protective Action Criteria)

No PAC information available.

Regulatory Information

EPA Consolidated List of Lists

No regulatory information available.

DHS Chemical Facility Anti-Terrorism Standards (CFATS)

No regulatory information available.

Alternate Chemical Names

This section provides a listing of alternate names for this chemical, including trade names and synonyms.



Leave a Reply

Your email address will not be published. Required fields are marked *